The nebulizer lasts for an average of 90 nebulizations, each containing 10 ml of 0.9% saline solution. Please ensure that no salt water flows into the USB ports.

Please rinse both the USB port and the USB connector thoroughly with distilled water. You can use a disposable syringe for this. Then let them dry thoroughly.

Please don't. The inhaler can warp or even soften on the heater. It's best to remove the atomizer, dry it thoroughly with a cloth, open the sealing material, and place it in a living space.

Generally, yes. For smaller horses, the neck strap can be used. The sealing material can definitely be tightened. The inner circumference is up to 64 cm, and the inner opening measures approximately 16 cm x 23 cm.

The nebulizer is typically compatible with all medications suitable for nebulization with a mesh nebulizer. Due to the wide range of medications, we cannot guarantee whether a specific medication can be nebulized. This may also affect the lifespan of the nebulizer.

The nebulizer is tested with NaCl 0.9% solution.

The nebulizer's mesh has a mesh size of 5 micrometers. This corresponds to the mesh size of other nebulizers for horses. Physically and empirically, it can be assumed that nebulization with this mesh size will produce particles between 1 and 5 micrometers. However, particle size measurements have not yet been performed. Furthermore, the nebulizer is positioned directly in front of the horse's nostrils, which significantly reduces droplet conglomeration compared to other nebulizers.

If 15 ml of NaCl is inhaled daily, the nebulizer will last for at least 90 uses with proper care. You can find a new nebulizer in our Spare Parts/Nebulizer section. Our nebulizer is also designed for repairability and durability. Most parts can be unscrewed and replaced if damaged. Please see the Spare Parts section.

The battery lasts for at least 30 applications of 15 minutes each.

The nebulizer holds 15 ml of liquid.

No, so far the inhaler has fit all horses. Please check the size information .

The inhaler is made of polylactic acid, polycarbonate, and thermoplastic urethane. These plastics are food-safe.

Since we personally have not owned any other inhaler, we cannot make a comparison.

Yes, the inhaler is safe.

You can usually hear when the fluid is used up. The fogging noise then stops. You can also see the fluid level when viewed against the light. Mist no longer comes out of the front or bottom.

The nebulization takes place directly in front of the nostrils. Naturally, your horse cannot absorb the entire inhaled product. This also applies to all other inhalers and is due to so-called dead volumes. However, due to the direct nebulization in front of the nostrils and the optimized flow pattern, the yield is comparable to or even higher than with other inhalers.

This is not planned for the time being. Experience has shown that it is not the durability of the plate or the electronics that limits the nebulizer's lifespan, but rather corrosion of the USB connector due to spilled NaCl solution.

With very careful handling and very good care, the nebulizer can therefore far exceed the specified service life ☺️

The problem occurs when dust has entered the membrane. The following generally helps:

1) Carefully blow out the liquid container, contact mesh and USB cable.

2) Use a syringe to inject distilled water into the container and onto the membrane under slight pressure to loosen any adhesion caused by the salt.

3) Fill the container halfway with distilled water, close it, shake well and pour it out.

4) Allow the nebulizer and cable to dry overnight at room temperature (21 °C) (please DO NOT place on the heater)

The nebulizer has an outlet for condensate and body fluids below the membrane. This prevents the accumulation of fluid on the membrane and ensures proper function.

If it is actually leaking, you can tighten the four screws by about half a turn using the included wrench.

Obwohl sämtliche Metallteile versiegelt, brüniert oder aus Edelstahl gefertigt sind, kann es bei längerem Kontakt mit Feuchtigkeit zu Korrosion kommen. Zur Vorbeugung empfehlen wir, alle magnetischen Bauteile nach der Anwendung abzunehmen, damit sich keine Feuchtigkeit zwischen den Bauteilen sammeln kann.
Sollte dennoch Korrosion auftreten, können Karabinerhaken mit WD-40 gereinigt werden. Kunststoffteile lassen sich mit Isopropanol und einem weichen Tuch säubern, Magnete vorsichtig mit einem Glasfaserstift (z. B. BERNSTEIN Ø 4 mm). Anschließend können die Oberflächen mit einem Schutzlack (z. B. NEUFELD® Lackstift Schwarz Glänzend, 12 ml) versiegelt werden. Beide Produkte sind u. a. über Amazon erhältlich.
Zusätzlich besteht beim Equilator die Möglichkeit, einzelne Baugruppen auszutauschen, falls dies für Sie einfacher oder praktikabler ist.

This is generally due to air bubbles stuck on the inside of the mesh. It can also happen that fluid collects on the outlet side of the mesh. Drops form on the mesh. Cleaning the mesh with a frog cleaner often helps. Simply take the cleaner or a drop of dish soap and rub it over it.

If everything lights up and can be switched on, but the nebulization performance decreases, then you need a new plate. If the lamp no longer lights up when switched on or keeps going out on its own, or the screw connection is worn out, you need a new nebulizer.